1. when you do  the LOADEPIC <project> make sure the line that says "pulse
divisor....." has a low number (normally 8).  You should have set that to 8 when you
first built the .JOY file ( to change: JOYSTICK /P8 /Q <project> )

2. run TESTEPIC to make sure the Px bars are moving. 0=ailerons,
1=elevators,2=rudder, 3=throttle.
3. type EXIT to return to Windows.
4. verify resources.
    settings/control panel/system/device manager/sound,video game
controllers
    verify gameport X'd out
    R&R should look ok    (click on it)
    click on "properties"
    click on "resources"
    verify ports are 200,201,202-207,280-28F (change if wrong)
    should be no conflicts.
    click "OK"
5. click on Game Controllers
6. If there are more than one listed, do any say "OK".
    If so, remove the others
7. If nothing is listed, try to add a 3 axis 4 button joystick.
    If you can add, does it say "OK"?
8. If not, remove all game controllers,  exit Game Controllers, go back to control panel/system/device
manager
    Remove R&R
    a. click on "Computer" (at top of list)
    b. properties
    c. reserve resources
    d. input/output(I/O)
    e. add
    f. start value-200 end value-207
    g. OK
    h. OK
    i. Restart
    j. control panel/add new hardware/next/next/no/next/no/sound,video, and
game controllers/
        next/R&R/next/next/finish/yes (will restart)
    k. after rebooting
        open an MS-DOS session
        CD\EPIC
        LOADEPIC
        will load DEFAULT
        TESTEPIC
        verify Px bars are moving
        Ctrl-C to exit
        EXIT
    l. control panel/system/device manager/sound,video, and game controllers

        R&R should be listed with no redX or yellow!
    m. click on R&R/properties
        there should be no check on "disable in this hardware profile" or
"remove..."
    n. click on resources
        verify ports are 200,201,202-207,280-28F
        if different "change settings" for any that are different.
        if asked to reboot, yes.
    o. after system is back up, repeat steps k,l,m,n
        if ok, repeat step 5,6,7
        if still no "OK" in Game Controllers go to web site FAQ and get
document on ICU from Intel to disable PNP resources.