770-427-3116 / 800-282-7989 Fax - 770-424-3488
Not Shown. For 71 1010 Jig Transit. The micrometer measures horizontal or vertical displacement from a line of sight. Its range is +/- 0.100 inch. Has uniformly graduated, red and black main scale reading directly to 0.001 inch. Vernier scale reads to 0.0001 inch. Has dustproof cover glass and split clamp for mounting. Can be adjusted and calibrated without removal from instrument telescope.
71 1113 Metric Micrometer
Same as 71 1111 except its range is +/-
2.0mm and the main scale reads directly to 0.02mm. The vernier
scale reads to 0.002mm. In addition to Jig Transits, micrometer
can also be used with 71 3010 Tilting level. Use in conjunction
with WYTEFACE Metric Optical Alignment Scale 71 6041.
71 1130 Circular Auto-Reflection Mirror
For 71 1010 Jig Transit. A circular
front surface mirror, 2 5/16 in. in diameter, is used for
establishing a plane perpendicular to a line of sight. The mirror
is optically flat to within 1/4 wave length of light. It can be
mounted on either end of the axle of a jig transit telescope and
can be adjusted to square with the axle by means of two adjusting
screws.
71 1140 WYTEFACE Auto-Reflection Target
This aluminum target, when mounted on
the objective end of all jig transit telescopes or on an optical
micrometer, will provide a point of reference on the line of
sight for auto-reflection.
71 1211 Auto-Collimation Conversion Unit
The unit converts a jig transit
telescope, line of sight telescope, and tilting level telescope
into auto-collimating telescopes. The unit comes complete with a
light plug assembly, cord, switch, and fixed 6-volt transformer.
71 1260 Prismatic Eyepiece
The prismatic eyepiece is used in very
low setups, or when working close to walls, columns, or similar
obstructions. It may be rotated through 360 degrees, giving an
erect but reversed image.
71 3250 Coincidence Vial
This level can be used for either the
plate level or the telescope level on jig transits. It can also
be attached to any fixture, gauge, or machine bracket. Two 7/32
in. diameter holes, spaced 3 1/2 in. on centers, are provided for
mounting. The level vial has a sensitivity of 20 seconds of arc
per 2 mm movement.
71 3260 Level Vial
This level can be used for either the
plate level or the telescope level on jig transits. It can also
be attached to any fixture, gauge, or machine bracket. Two 7/32
in. diameter holes, spaced 3 1/2 in. on centers, are provided for
mounting. The level vial has a sensitivity of 20 seconds of arc
per 2 mm movement. (Standard with 71 1010).
Call or e-mail for your quote.
Specifications subject to change without notice please call to verify.